Edition
Sunday, November 22
Updated
1:06 PM EST

Jobsite hacks

How to check whether your level still reads true, and how a bubble vial works

Carpenter Ethan James of The Honest Carpenter walks through spirit levels in a 10-minute video: why the bubble centers, which length to pick for the job, and a flip test that shows in seconds whether a vial has gone out of true.

A spirit level is named for the alcohol in its vials, which does not freeze and crack the tube in cold weather, James explains. The vials are not straight. They are slightly curved, often barrel-shaped at the middle, so the bubble rides to the highest point. The center vial is set parallel to the long edges and reads level. The end vials sit square to the edges and read plumb. A bubble centered between the lines means the surface is level or plumb.

A level reads only as well as the surface under it. A short torpedo level on a board with a slight crown or sag can read level in one spot and off in the next. A longer level bridges those bumps, which is why framers reach for 6-foot and 8-foot models. James keeps a 4-foot, a 2-foot and a torpedo on hand. Some vials carry extra lines for set slopes, which plumbers use to check drain pitch. Past about 12 to 16 feet a bubble level is the wrong tool, and a builder's level or a laser takes over.

With the bubble inside the lines, a good level is accurate to about half a millimeter per meter, or roughly 0.03 degrees, James says. A drop or rough handling at the factory can knock a vial out, so he tests every level, new ones included. For a plumb vial, hold one edge against a vertical surface and note the bubble, then roll the level over on the same axis so the other edge touches and read the same vial again. For the center vial, take a reading, swing the tool end for end and read again. Matching readings mean the vial is true. A bad vial can sometimes be replaced, but James says he would rather buy a new level.

He also compares the two common bodies. I-beam levels cost less and wear out sooner. Box-beam levels have four closed walls, resist bending and twisting and cost more, and he recommends them for professionals.

Why it matters: Walls, headers and deck ledgers all get set off a level. A one-minute flip test on each vial catches a tool that has been knocked out of true before it puts a whole frame out of plumb.

Sources

More in jobsite hacks